At present, the commonly used projector housings on the market basically use 1W high-power LEDs (each LED component will have a high-efficiency lens made of PMMA, and its main function is to secondarily distribute the light emitted by the LED, which is two Secondary optics), and a few companies have chosen LEDs with 3W or higher power because of the good heat dissipation technology. Suitable for large-scale occasions and lighting, construction Lighting. Next, Aluminum Lamp Housing Supplier introduces the precautions for the use of the LED flood light housing.

1. High-purity aluminum reflector, accurate beam and good reflection effect.

2. Symmetrical narrow-angle, wide-angle and asymmetric light distribution systems.

3. The light bulb can be replaced with an open-back type, which is easy to maintain.

4. The lamps are all attached with a scale plate to facilitate the adjustment of the irradiation angle.

Through the above introduction, Die-Cast Housing Manufacturers hopes that you can simply refer to the content of this article in future use.


コメント